R1250GS(A) Toolbox (Also fits Rallye)
This is the new design of the standard toolbox revised to fit the new R1250GS (if you require the standard pannier rail variant, please select R1250GSA in the drop down) it is powder coated in satin black over aluminium with three 3mm thick stainless steel brackets to hold the box solid. It is professionally hand finished and TIG welded using good thick aluminium material. Its certainly the strongest box currently on the market in our opinion. It is not mass produced, with each one being made to order.
Some may know that Nippy Norman does an `adaptor kit` for a Touratech tool box to fit a GS - the adaptor kit is actually made by us but I`ve never been happy with `just` the two anchor points which the adaptor kit hangs off.
Our toolbox incorporates the following features which represent an improvement over other mass produced boxes on the market:
Good, high quality hinges.
High quality stainless steel fasteners throughout.
High quality lock with 2 keys.
The box locates on four existing M8 locating points using three tough stainless steel brackets - this holds the box much better.
The box is Tig welded and finally hand finished to give it that quality, individually made feel about it. This item is NOT mass produced and this can be seen in the final finishing of the toolbox - no two are ever alike.
I had tried to make it fully waterproof but no matter what I tried it was impossible to achieve, to get round this I have fitted 2 drain holes to allow water which may get in to drain out. I personally always stick my gear in plastic bags when I use the toolbox anyway and I would suggest this to all users.
It comes with full instructions and fittings.
Length = 300mm
Depth = 74mm
Width (widest) = 181mm
Width (shortest) = 105mm
Just what I needed, looks excellent, simple to fit. SUPERB quality as always. Customer service just the best.
What can I buy off you next. ??
Steve Laughton | Lancashire | October 2021
Excellent product and service
Excellent product, perfect for it's intended purpose as a utility toolbox and the service from Cymarc was fantastic as always.
Robert Jeffries | Cwmbran | December 2020
1250 GSA TOOLBOX
WELL MADE AS ALWAYS. BIT OF HEAD SCRATCHING NEEDED TO FIT. I NEEDED ALL THE PARTS IN THE FITTING KIT TO SET THE BOX BACK FROM THE PANNIER RAILS .
LARGE ENOUGH FOR A KRIEGA TOOL ROLL, MULTI TOOL AND TYRE PRESSURE GUAGE WITH ROOM TO SPARE.
Barry Millington | BRIDGE OF ALLAN | October 2019
another quality product from cymarc, the alloy toolbox is really well made fits pannier rails superbly no problems with fitment highly recommended.
tony wheeler | south lincs | June 2019