Call Us On: 07715 681911 (Mike & Aaron) or 07713 789365 (After hours number) 
R1200GSA LC Touring Front Engine Protector (Also fits Rallye)

R1200GSA LC Touring Front Engine Protector (Also fits Rallye) [star-value] Stars (1)

£63.60
You Will Earn 63 points which is the equivalent of £6.30

PRODUCT DESCRIPTION

This was my first product for the new 2013 R1200GS LC which has been redesigned to fit the new GSA, made from good quality stainless steel and finished in a satin black powder coat. Its a front crud catcher designed to stop the bottom front of the engine getting `shot blasted` by grit and crud off the road - once water gets beneath the engine finish it can corrode terribly and look a right mess. Its also very expensive to sort out!

This Front Engine Ptotector locates on 4 of the existing fastening points and is held off the cover by 4 very high quality stainless steel tubes. The Protector is held in place by 4 stainless steel fasteners with also come with the product. The plate itself has been laser profiled and is made from high quality brushed stainless steel which is hand finished. I have also incorporated the `GSA` logo which has been laser profiled out of the surface of the plate - it makes the part look very nice indeed.

It has been titled `touring` as it is larger than the smaller `sports` one and extends higher up the engine case giving better protection to the bottom of the engine case.

To fit only takes minutes and with a wipe with WD40 will look great for years to come.

It comes with full fitting instructions and you just have to contact me if you need any help over the phone fitting it.

PRODUCT INFORMATION

CUSTOMER REVIEWS

Write an online review and share your thoughts with other shoppers!
Nick - Leicestershire5 Stars
A very substantial well made guard to take the battering instead of the front of your expensive engine block, a very good fit really easy to fit and comes with a very good set of instructions but if any problems, the lads are only a phone call away.
I also have a fender extender and it misses this by about 10mm
Does as it says on the tin